Tree Trimming is a dangerous job. As you can see from the picture above it does require you to climb high in the tree and start trimming from the top. Make sure that if you decide to do it on your own you have the best safety equipment or please give our service a try by call us for a free estimate 719-596-6696 and ask for Mike.
• Always use proper personal protective equipment as recommended by the manufacturer’s operating manual, including eye, face, head, hand, and foot protection.
• Broken or hanging branches, attached vines, or a dead tree that is leaning. All of these hazards can cause an injury.
• If you have to cut a dead tree, be careful. The top could break off.
• If the tree is broken and under pressure, make sure you know which way the pressure is going. If not sure, make small cuts to release some of the pressure before cutting up the section.
• Be careful of young trees that other trees have fallen against. They act like spring poles and can propel back. (Many professional loggers have been hurt in this manner.)
• A tree may have not fallen completely to the ground and be lodged against another tree. Extreme care must be taken to safely bring the trees to the ground.
• If possible, avoid felling into other trees or objects. Don’t turn your back on the tree as it falls, and hide behind a standing tree if possible.
• As trees fall through other trees or objects, branches and objects may get thrown back towards logger. More people are killed while felling trees than during any other logging activity. These accidents CAN be avoided!
• ALWAYS ASSUME THAT POWER LINES ARE ENERGIZED!
• If clearing trees, contact the utility company to discuss de-energizing and grounding or shielding of power lines.
• Extreme caution is necessary when moving ladders and other equipment around downed trees and power lines.
• Always perform a hazard assessment of the work area prior to start of work. To “fell a tree” means more than just cutting it down. Felling means to cut the tree in such a way that it falls in the desired direction and results in the least damage to the tree. To safely fell a tree, you must: Eliminate or minimize exposure to potential hazards found at the tree and in the surrounding area.
• What hazards are present in the area where the logger will be working.
• Determine the felling direction and how to deal with forward lean, back lean, and/or side lean.
• Provide a retreat path so the logger can reach safety while the tree is falling.
• Determine the proper hinge size to safely guide the tree in its fall.
• Proper felling methods allow the logger to safely fell the tree.
• Look out for Hazards and make sure you know where everyone is located!